PeerMotion

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a TimeSeries object which, similar to a Path TimeSeries, the load factor obtained is dependent on a series of points obtained from a file. The difference is that the file is obtained from the original Peer strong motion database using an internet connection.

timeSeries PeerMotion $tag $eqMotion $station $type $factor <-dT $dT> <-nPTS $nPts>

---

$tag	unique tag among TimeSeries objects.
$eqMotion	the PEER name for the earthquake
$record	a combination of PEER abbreviated station name and direction
$type	type can be either -ACCEL or -DISP depending on whether you want accelerations or displacements
$factor	factor to be applied to the data points, if accel record type you want to specify G
$nPts	optional, if provided will set the variable nPts equal to number of data points found in record
$dT	optional, if provided will set the variable dT equal to time interval between points in the record

NOTES:

• If the time in the domain does not match a data point in record, linear interpolation is performed between nearest points in record.
• The command can be used with the results obtained from the searchPeerNGA command (hence the craziness of the $eqMotion names).
• An internet connection is required to run command.

EXAMPLE

To create 2 time series for two horizontal motions recorded for the Borrego Mtn 1968-04-09 earthquake recorded at the USGS 117 El Centro Array #9 station

timeSeries PeerMotion 1 BORREGO A-ELC180 -ACCEL $G -dT dt -NPTS nPts

timeSeries PeerMotion 2 BORREGO A-ELC270 -ACCEL $G

---

Code Developed by: fmk