AxialSpHD Material

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a uniaxial AxialSpHD material object. This material model produces axial stress-strain curve of elastomeric bearings including hardening behavior.

uniaxialMaterial AxialSpHD $matTag $sce $fty $fcy <$bte $bty $bth $bcy $fcr $ath>

---

$matTag	integer tag identifying material
$sce	compressive modulus
$fty $fcy	yield stress under tension ($fty) and compression ($fcy) (see note 1)
$bte $bty $bth $bcy	reduction rate for tensile elastic range ($bte), tensile yielding ($bty), tensile hardening ($bth) and compressive yielding ($bcy) (see note 1)
$fcr	target point stress (see note 1)
$ath	hardening strain ratio to yield strain (see note 1)

NOTES:

1) Input parameters are required to satisfy followings.

$fcy < 0.0 < $fty

0.0 <= $bty < $bth < $bte <= 1.0

0.0 <= $bcy <= 1.0

$fcy <= $fcr <= 0.0

1.0 <= $ath

     

---

EXAMPLE:

AxialSpHD_sample.tcl

---

Code Developed by: mkiku