Element Command: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 54: | Line 54: | ||
**[[Elastomeric Bearing Element]] | **[[Elastomeric Bearing Element]] | ||
**[[Flat Slider Bearing Element]] | **[[Flat Slider Bearing Element]] | ||
**[[Single Friction Pendulum Bearing Element]] | **[[Single Concave Friction Pendulum Bearing Element]] | ||
**[[Triple Friction Pendulum Bearing Element]] | **[[Triple Friction Pendulum Bearing Element]] | ||
Revision as of 23:00, 29 July 2011
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to construct an element and add it to the Domain.
| element eleType? arg1? ... |
The type of element created and the additional arguments required depends on the eleType? provided in the command.
NOTE:
The valid queries to any element when creating an ElementRecorder are documented in the NOTES section for each element.
The following contain information about eleType? and the args required for each of the available element types:
- Zero-Length Elements
- Truss Elements
- Beam-Column Elements
- Joint Elements
- Link Elements
- Bearing Elements
- Quadrilateral Elements
- Triangular Elements
- Brick Elements
- up Elements
- misc