Uniform Excitation Pattern

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

The UniformExcitation pattern allows the user to apply a uniform excitation to a model acting in a certain direction. The command is as follows:

pattern Uniform $patternTag $dir -accel $tsTag <-vel0 $ver0>

---

$patternTag	unique tag among load patterns
$dir	direction ground motion acts
$tsTag	tag of the TimeSeries series defining the acceleration history.
vel0	optional, the initial velocity, default=0.0.

NOTES:

1. The responses obtained from the nodes for this type of excitation are RELATIVE values, and not the absolute values obtained from a multi-support case.

---

Code Developed by: fmk