Rayleigh Damping Command

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to assign damping to all previously-defined elements and nodes. When using rayleigh damping in OpenSees, the damping matrix for an element or node, D is specified as a combination of stiffness and mass-proportional damping matrices:

D = $alphaM * M + $betaK * Kcurrent +$betaKinit * Kinit + $betaKcomm * KlastCommit

rayleigh $alphaM $betaK $betaKinit $betaKcomm

---

$nodeTag	integer tag identifying node
$alphaM	factor applied to elements or nodes mass matrix
$betaK	factor applied to elements current stiffness matrix.
$betaKinit	factor applied to elements initial stiffness matrix.
$betaKcomm	factor applied to elements committed stiffness matrix.

NOTE:

1. The command overwrites any existing damping coeeficients at the Elements and Nodes.
2. The following paper is something that you should read if you are new to the damping and nonlinear analysis. Finley A. Charney, "Unintended Consequences of Modeling Damping in Structures", J. Struct. Engrg. Volume 134, Issue 4, pp. 581-592 (April 2008)

EXAMPLE:

rayleigh 0.01 0.02 0.0 0.0

---

Code Developed by: fmk