EleResponse Command

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to obtain the same element quantities as those obtained from the element recorder at a particular time step.

eleResponse $eleTag $arg1 $arg2

---

$eleTag	integer tag identifying element
$arg1, $arg2	same arguments as those specified in element recorder. These arguments are specific to the type of element being used.

EXAMPLE:

For a simple truss example if these are the recorder commands used:

recorder Element -time -ele 1 2 3 -file a.out axialForce

recorder Element -time -ele 1 2 3 -file b.out material stress

then these are the corresponding eleResponse commands

set a [eleResponse 1 forces]

set b [eleResponse 1 material stress]

---

Code Developed by: fmk