Shell Element

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a ShellMITC4 element object, which uses a bilinear isoparametric formulation in combination with a modified shear interpolation to improve thin-plate bending performance.

element ShellMITC4 $eleTag $iNode $jNode $kNode $lNode $secTag

---

$eleTag	unique element object tag
$iNode $jNode $kNode $lNode	four nodes defining element boundaries, input in counter-clockwise order around the element.
$secTag	tag associated with previously-defined SectionForceDeformation object. Currently must be either a PlateFiberSection, or ElasticMembranePlateSection

---

NOTE:

1. The valid queries to a Quad element when creating an ElementRecorder object are 'forces', 'stresses,' and 'material $matNum matArg1 matArg2 ...' Where $matNum refers to the material object at the integration point corresponding to the node numbers in the isoparametric domain.
2. It is a 3D element with 6 dofs and CAN NOT be used in 2D domain.

---

EXAMPLE:

set t 100.0
model basic -ndm 3 -ndf 6
nDMaterial ElasticIsotropic 1 200000 0.3
nDMaterial PlateFiber 4 1
set secArgs "7"
section PlateFiber $secArgs 4 $t
set EleType ShellMITC4
block2D $n1 $n2 1 1 $EleType $secArgs {
    1   0.0   0.0  0.0
    2   0.0    10  0.0
    3  1000    10  0.0
    4  1000   0.0  0.0
} 

REFERENCES:

Dvorkin,Bathe, A continuum mechanics based four node shell element for general nonlinear analysis, Eng.Comput.,1,77-88,1984

---

Code Developed by: Leopoldo Tesser, Diego A. Talledo, Véronique Le Corvec