FrictionModel Command

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

The frictionModel command is used to construct a friction model object, which specifies the behavior of the coefficient of friction in terms of the absolute sliding velocity and the pressure on the contact area. The command has at least one argument, the friction model type. Each type is outlined below.

frictionModel frnMdlType? arg1? ...

---

The type of friction model created and the additional arguments required depend on the frnMdlType? provided in the command.

The following contain information about frnMdlType? and the args required for each of the available friction model types:

• Coulomb Friction
• Velocity Dependent Friction
• Velocity and Pressure Dependent Friction
• Multi-Linear Velocity Dependent Friction

The following friction model response quantities can be recorded through the element, as long as the element has a friction model associated with it:

normalForce

velocity

frictionForce

COF

EXAMPLE

recorder Element -file Elmt.out -time -ele 1 frictionModel normalForce