Plain Numberer

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a Plain degree-of-freedom numbering object to provide the mapping between the degrees-of-freedom at the nodes and the equation numbers. A Plain numberer just takes whatever order the domain gives it nodes and numbers them, this ordering is both dependent on node numbering and size of the model. The command to construct a Plain numberer is a follows:

numberer Plain

---

NOTES:

• For very small problems and for the sparse matrix solvers which provide their own numbering scheme, order is not really important so plain handler is just fine. For large models and anslsyis using solver types other than the sparse solvers, the order will have a major impact on performance of the solver and the plain handler is a poor choice.

---

Code Developed by: fmk