Linear Algorithm

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a Linear algorithm object which takes one iteration to solve the system of equations.

<math> \Delta U = - K^{-1}R(U),\!</math>

algorithm Linear <-initial> <-factorOnce>

-secant	optional flag to indicate to use secant stiffness
-initial	optional flag to indicate to use initial stiffness
-factorOnce	optional flag to indicate to only set up and factor matrix once

---

NOTES 1) as the tangent matrix typically will not change during the analysis in case of an elastic system it is highly advatageous to use the -factorOnce option. Do not use this option if you have a nonlinear system and you want the tangent used to be actual tangent at time of the analysis step.

---

Code Developed by: fmk