Modified Newton Algorithm

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a ModifiedNewton algorithm object, which uses the modified newton algorithm to solve the nonlinear residual equation. The command is of the following form:

algorithm ModifiedNewton

---

NOTES:

---

REFERENCES:

Read the page at Wikipedia

---

THEORY:

The theory for the ModifiedNewton method is similar to that for the Newton-Raphson method. The difference is that the tangent at the initial guess is used in the iterations, instead of the current tangent. The Modified Newmark method is thus an iterative method in which, starting at a good initial guess <math>U_0</math> we keep iterating until <math>\Delta U</math> is small enough using the following:

<math> \Delta U = - K_0^{-1}R(U_n),\!</math>

<math> U_{n+1} = U_n + \Delta U\,\!</math>

where:

<math>K_0 = \frac{\partial R(U_0)}{\partial U}\,\!</math>

The advantage of this method over the regular Newton method, is that the system Jacobian is formed only once at the start of the step and factored only once if a direct solver is used. The drawback of this method is that it requires more iterations than Newton's method.

---

Code Developed by: fmk