Element Command: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 84: | Line 84: | ||
* Contact Elements | * Contact Elements | ||
**[[SimpleContact2D]] | **[[SimpleContact2D|SimpleContact2D Element]] | ||
**[[SimpleContact3D]] | **[[SimpleContact3D|SimpleContact3D Element]] | ||
**[[BeamContact2D]] | **[[BeamContact2D|BeamContact2D Element]] | ||
**[[BeamContact3D]] | **[[BeamContact3D|BeamContact3D Element]] | ||
**[[BeamEndContact3D]] | **[[BeamEndContact3D|BeamEndContact3D Element]] | ||
Revision as of 01:13, 8 March 2011
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to construct an element and add it to the Domain.
| element eleType? arg1? ... |
The type of element created and the additional arguments required depends on the eleType? provided in the command.
NOTE:
The valid queries to any element when creating an ElementRecorder are documented in the NOTES section for each element.
The following contain information about eleType? and the args required for each of the available element types:
- Zero-Length Elements
- Truss Elements
- Beam-Column Elements
- Joint Elements
- Link Elements
- Bearing Elements
- Quadrilateral Elements
- Brick Elements
- up Elements
- misc