Section Command: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
mNo edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 24: | Line 24: | ||
*[[NDFiber Section]] | *[[NDFiber Section]] | ||
*[[Wide Flange Section]] | *[[Wide Flange Section]] | ||
*[[RC Section]] | |||
*[[Parallel Section]] | *[[Parallel Section]] | ||
*[[Section Aggregator]] | *[[Section Aggregator]] | ||
| Line 31: | Line 32: | ||
*[[Bidirectional Section]] | *[[Bidirectional Section]] | ||
*[[Isolator2spring Section]] | *[[Isolator2spring Section]] | ||
Latest revision as of 22:19, 8 May 2013
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to construct a SectionForceDeformation object, hereto referred to as Section, which represents force-deformation (or resultant stress-strain) relationships at beam-column and plate sample points.
| section secType? secTag? arg1? ... |
The type of section created and the additional arguments required depends on the secType? provided in the command.
NOTE:
The valid queries to any section when creating an ElementRecorder are 'force', and 'deformation'. Some sections have additional queries to which they will respond. These are documented in the NOTES section for those sections.
The following contain information about secType? and the args required for each of the available section types: