Dear Community
I am new to parallel processing. So, I wanted to learn it. I installed all the requirements as per Dr. FMK's instructions. Then, I executed the ex4.tcl in my OpenSeesSP console. It threw an error saying that "Warning: No numberer type exists (Plain, RCM only)". Can anyone help me to understand the problem? Thanks. I add the ex4.tcl code below:
set pid [getPID]
set np [getNP]
puts $np
if {$np != 1} {
puts "ONLY WORKS FOR 2 PROCESSORS"
exit
}
model BasicBuilder -ndm 2 -ndf 2
uniaxialMaterial Elastic 1 3000
if {$pid == 0} {
node 1 0.0 0.0
node 4 72.0 96.0
fix 1 1 1
element truss 1 1 4 10.0 1
pattern Plain 1 "Linear" {
load 4 100 -50
}
} else {
node 2 144.0 0.0
node 3 168.0 0.0
node 4 72.0 96.0
fix 2 1 1
fix 3 1 1
element truss 2 2 4 5.0 1
element truss 3 3 4 5.0 1
}
# ------------------------------
# Create the recorders
# ------------------------------
recorder Node -file node4.out.$pid -time -node 4 -dof 1 2 disp
# ------------------------------
# Start of analysis generation
# ------------------------------
# Create the system of equation, a SPD using a band storage scheme
system Mumps
numberer ParallelPlain
constraints Transformation
integrator LoadControl 0.1
test NormDispIncr 1.0e-12 3
algorithm Newton
analysis Static
analyze 10
print node 4
Warning No Numberer type exists
Moderator: selimgunay