How to run dll file in Opensees?
Posted: Tue Jan 23, 2018 3:29 am
Dear fmk and all
I have a dll file that is written by someone else. I put it in the same folder as my OpenSees executable.
But I get this warning "WARNING could not create uniaxialMaterial MaxStrainRange"
What should I do to make this file work properly?
Your kindness is highly appreciated. I look forward to hearing from you.
Best,
Mojtaba
I have a dll file that is written by someone else. I put it in the same folder as my OpenSees executable.
But I get this warning "WARNING could not create uniaxialMaterial MaxStrainRange"
What should I do to make this file work properly?
Your kindness is highly appreciated. I look forward to hearing from you.
Best,
Mojtaba