Problem facing in running the example 7 3D Frame

[diptiranjanmajhi]

Hello Sir,
I am trying to run the example 7 3D Frame from the Examples Manual. Here I am providing the link:
http://opensees.berkeley.edu/wiki/index ... _W-Section

I am running the programme "Ex7.Frame3D.build.RCsec.tcl".
This programme is not running.
I think the main programme is somewhere stuck in between "DisplayModel3D.tcl" programme.

Please help me to solve this problem.
Thank you.

[fmk]

remove the display options and see if it runs.

[diptiranjanmajhi]

Thank you for your prompt reply.
Yes, after removing this it is perfectly running.
# Define DISPLAY -------------------------------------------------------------
set xPixels 1200; # height of graphical window in pixels
set yPixels 800; # height of graphical window in pixels
set xLoc1 10; # horizontal location of graphical window (0=upper left-most corner)
set yLoc1 10; # vertical location of graphical window (0=upper left-most corner)
set dAmp 2; # scaling factor for viewing deformed shape, it depends on the dimensions of the model
DisplayModel3D NodeNumbers $dAmp $xLoc1 $yLoc1 $xPixels $yPixels

I think it is used for the displaying the deformed and mode shape of the system. It is not affecting the calculation and all.

I have one more question. Where to place the ground motion file?
I want to run "Ex7.Frame3D.analyze.Dynamic.EQ.Uniform.tcl" file after the model built for the same example.
I am putting all the files in the same directory and running from there. But I am getting an error.
Cannot open ../GMfiles/H-E12140.at2 for reading
can't read "dt": no such variable

Please help me to solve this problem.
Thank you for your understanding.