eleRange command

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
jaj14
Posts: 3
Joined: Thu Jan 21, 2010 3:08 pm
Location: Blacksburg, VA

eleRange command

Post by jaj14 »

Can the eleRange command be used with the eleLoad command (so to add any the load to a range of elements?). It is not letting me, and the only times the eleRange command appeared in the documentation was for the recorder and region commands, so I wasn't sure if it was only applicable then. Thanks!
Top
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:
Contact fmk

Post by fmk »

no .. it is a good idea though .. could you add it to the requirements forum for me.
Top
Post Reply

Return to “OpenSees.exe Users”