"restore" command

marian · Post by **marian** » Wed Sep 16, 2009 8:37 am

Hi,
I would like to break an analysis during the process, to save the state of the model, and to restore it latter. Is it possible by the “save” and “restore” command?
Trying to use these commands I keep getting these error messages:
“Invalid command “restore”” and “Invalid command “save””.
Does anyone know what kind of mistake I’m making?
Thanks

silvia · Post by **silvia** » Wed Sep 16, 2009 9:40 am

have you used them as they are given in the manual?
i haven't used them in a while.

marian · Post by **marian** » Thu Sep 17, 2009 2:21 am

I’ve added the command “save” at the end of the analysis and not in a while cycle, I’ve used the command as given in the manual:
save $commitTag
I’ve added an integer after the command “save” and I’ve obtained the error message:
“Invalid command “save””
Can you help me to understand what kind of mistake I’m making for using the command?

Many thanks.

silvia · Post by **silvia** » Thu Sep 17, 2009 6:42 am

Frank may have removed them.
we have to wait for his return.