Element recorder
Moderators: silvia, selimgunay, Moderators
Element recorder
Hi all Openseesers,
I want to record shear force(or stress) at an element. Let's say I want to get the data of the second integration point assuming that element has 5 integration points.
Thanks for the helps.
I want to record shear force(or stress) at an element. Let's say I want to get the data of the second integration point assuming that element has 5 integration points.
Thanks for the helps.
Thanks for the answer.
However when I use the code in the manual
it generates a file which contains no data.I also assumed that command will not produce any shear force vs displacement(or at least only shear force) since section output may only give fx and mx(axial load and torsion?)?
However when I use the code in the manual
Code: Select all
recorder Element -file ele1sec1Force.out –time -ele 1 section 2 force
it depends on whether you have aggregated shear, as elastic shear.
no, you will not get shear deformation.
there is no real shear deformation in the element, unless you aggregate it elastically.
no, you will not get shear deformation.
there is no real shear deformation in the element, unless you aggregate it elastically.
Silvia Mazzoni, PhD
Structural Consultant
Degenkolb Engineers
235 Montgomery Street, Suite 500
San Francisco, CA. 94104
Structural Consultant
Degenkolb Engineers
235 Montgomery Street, Suite 500
San Francisco, CA. 94104
-
- Posts: 15
- Joined: Sun Dec 17, 2006 2:21 am
- Location: kntu university of technology