uniaxialMaterial SmoothSteel01

civilmanjun · Post by **civilmanjun** » Tue Dec 11, 2007 10:50 pm

I'm in trouble with following problem, please help me, thanks.
when i execute the commands, the following message occur:

WARNING could not create uniaxialMaterial SmoothSteel01
while executing
"uniaxialMaterial SmoothSteel01 1 $sigmaY $E $b $smoothgama $smootheta"
<file "exampke3b.tcl" line 19>

silvia · Post by **silvia** » Wed Dec 12, 2007 6:53 am

i think you need to run their version of opensees.

civilmanjun · Post by **civilmanjun** » Wed Dec 12, 2007 10:38 pm

other example could work properly, for instance, example3a, example20a, example23a, and so on. only example3b didn't work.

civilmanjun · Post by **civilmanjun** » Thu Dec 13, 2007 2:03 am

example3 didn't work, I tried it in opensees 1.7.4 and 1.7.5 version, but message said,
"warning could not creat uniaxialmaterial smoothsteel01
while executing
uniaxialmaterial smoothsteel01 1 $sigmaY $E $b $smoothgamma $smootheta
<file ''example3b.tcl> line 19"

please help me, thanks.

silvia · Post by **silvia** » Thu Dec 13, 2007 6:21 am

i don't think that material is in this version.

civilmanjun · Post by **civilmanjun** » Thu Dec 13, 2007 4:17 pm

silvia:

I run the example3b.tcl in opensees, version 1.7.4 and 1.7.5, but both didn't work.

you said, "I don't think that material is in this version."

which version is feasible for "uniaxialMaterial SmoothSteel01"?

thanks for you help.

silvia · Post by **silvia** » Thu Dec 13, 2007 9:05 pm

please contact the authors of that example.

civilmanjun · Post by **civilmanjun** » Thu Dec 13, 2007 10:03 pm

thanks for your advice.