fiber section axis in 2d?y is up?z is left?

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
hosseinigelekolai
Posts: 10
Joined: Mon Mar 02, 2009 12:49 am
Location: sharif university of technology

fiber section axis in 2d?y is up?z is left?

Post by hosseinigelekolai »

??????
Top
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:
Contact fmk

Post by fmk »

You can figure it out using a very simple elastic example of a cantilever with an elastic section .. So why don't you tell us?
Top
hosseinigelekolai
Posts: 10
Joined: Mon Mar 02, 2009 12:49 am
Location: sharif university of technology

hi

Post by hosseinigelekolai »

it is so nice of u
thank u so much

i did the job(modeling) but my result said that z is up and y is right.

but in the manual said that z axis in 2d modeling is the major axis????!!!!but it is not?

why?and also the whole example of 2d in the website should be wrong?????
Top
Post Reply

Return to “OpenSees.exe Users”