Bond_SP01 material can be used in 3D model?

wangweiyi · Post by **wangweiyi** » Wed Jan 20, 2010 5:54 am

I am modeling the behavior of a RC column in bidirectional load cycle test then I build 3D model for it.

I used fiber section and Aggregate shear deformation.The analytical results is OK.
But I want my model to be more precise so I add Bond_SP01 material to model slip deformation then the result become unbelievable.

Is Bond_SP01 material viable in 3D model?

Thanks!

Post by **fmk** » Wed Jan 20, 2010 12:42 pm

it should. the problem might be due to an error discovered in the material.

you might want to look at this discussion:

[url]
http://opensees.berkeley.edu/community/ ... hp?t=12096
[/url]

i have just recently been made aware of this error and the revised code will be in the next release (which will be out any day now assuming i am not hit with any more code changes from developers!)[/url]

wangweiyi · Post by **wangweiyi** » Wed Jan 20, 2010 10:24 pm

Thank you very much!