About MPCurveParams of ReinforcingSteel

davidjingyu · Post by **davidjingyu** » Tue Jul 28, 2009 11:41 pm

Dear

How can I set the MPCurveParams in ReinforcingSteel model.

As the default value for -MPCurveParams is 0.333 18 4.
and these parameters are sensitive to the structural behavior.

Does it have any limitations or literature support to set these parameters?

Can i set -MPCurveParams 0.5 18 4.

Thank you very much!

silvia · Post by **silvia** » Wed Jul 29, 2009 6:41 am

you have to contact the author on this one.....