Opensees output and GID

Julio Nakano · Post by **Julio Nakano** » Sun Nov 23, 2008 4:04 am

I have been using print command, but I have gotten more information than I need. I need just forces on nodes. Is there a specific command to get this?

PRINT COMMAND:

print bousinesq2.flavia.res node -flag 1

print bousinesq2.flavia.res ele -flag 1

Post by **fmk** » Tue Nov 25, 2008 1:33 pm

the forces you will see are from the applied nodes .. you can use a nodal recorder and ask for the 'unbalance' or the 'reaction', the unbalance being the applied loads.

jcnakano · Post by **jcnakano** » Thu Dec 04, 2008 1:56 pm

thank you fmk. It worked. I had a command, but it was at wrong place (end of program) Now, I´m working on format to GID