converge

from tongji · Post by **from tongji** » Thu Oct 23, 2008 4:40 pm

In my test, the gravity load is applied to a 6 story-2 bay frame first, then the static reversed load is applied. last, the point load is applied. the problem is when the point load is applied, it can't converge, whereas this problem didn't occur when the gravity load and the reversed load were applied. what should i do to make it converge?

silvia · Post by **silvia** » Thu Oct 23, 2008 7:51 pm

just use the scripts from the examples manual on how to deal with non-convergence.