Remove command

[lvjidaren]

Do you have ever used Remove Command? I have a question that I wanna to replace my beams when it sufferring from a time-history analysis, however, when I reconnected a new element between the two nodes, and run next time-history analysis, the OpenSEES would flash back without any indicator. So is there anyone knows the reason ?

[selimgunay]

It may have convergence issues at that point. Also adding a new element after removing another does nor seem to have much physical meaning, why do you do that?

[lvjidaren]

sry to reply your so late. I wanna to simulate the remove action to the model because of my researches.