Problem with using new uniaxialMaterial

[sarajo]

Hello everyone! I am trying to use a new material in OpenSees. I have the .dll file saved in the same folder as the .tcl file.But I am getting an error: WARNING could not create uniaxialMaterial..
I don't think there is anything wrong with the dll file because I get this error only on a desktop but the same code and .dll file works perfectly fine on my laptop. Can anyone please help?

[mpoliotti]

Hi, your laptop and your desktop have the same system 32 or 64 b ? If you have compiled your dll for 32b, it will only work there.

[sarajo]

Thanks for the reply mpoliotti !Both my laptop and desktop have 64b system. Is there anything else that could be the problem?

[mpoliotti]

Are you using the same version of Opensees and Tcl on both computers??

[sarajo]

Yes, I am using the same version of Opensees and Tcl on both computers..

[mpoliotti]

I dont know what can be the problem. Maybe you can try to compile the dll again on both computers.

[sarajo]

Ok.Thanks for your help!