Problem when using Joint2D element

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
WendyZhao
Posts: 6
Joined: Mon Oct 10, 2016 7:36 pm
Location: Chongqing University

Problem when using Joint2D element

Post by WendyZhao »

Dear all,
I have used Joint2D element in 6-story frame for interior and exterior joints, but opensees shows a quite small value for its fundamental T (about 0.05s). I have checked my tcl, but I dont know why the T is that small!
Top
KSH
Posts: 3
Joined: Tue May 15, 2018 3:03 am
Location: Guangzhou University

Re: Problem when using Joint2D element

Post by KSH »

I think you should check the stiffness in 6-story frame.
Top
Post Reply

Return to “OpenSees.exe Users”