problem on 2 direction pushover

[majidkhan]

i am trying to perform pushover analysis on 2 direction but "integrator displacement " valid 1 degree of freedom at node. give me some advise to do pushover on both x and y direction current. i use 2 integrator displacement is it correct?

pattern Plain $PushOverLoadPattern Linear {
load 3 0. 10000. 0. 0. 0. 0.
load 3 10000. 0. 0. 0. 0. 0.
}
integrator DisplacementControl 3 1 0.01
integrator DisplacementControl 3 2 0.01
analysis Static
analyze 1000

thanks

[Mohammadf]

Hi Dear Majid
you can perform your pushover in one direction and then save the model state by use loadConst command and then perform pushover on the second direction you want.

[majidkhan]

thanks
i know that. i had already done it
i compare this 2 pushover methods. and must do it on both direction concurrent

[fmk]

you cannot use displacement control to control 2 different dof.