Define the Section of the Multi-layer Shell element

saeedunknown · Post by **saeedunknown** » Sat Dec 26, 2015 11:33 pm

hi dears

Can we use this new model (A multi-layer shell element) instead of the ShellMITC4 with PlateFiberSection for the modeling of 3D slab shell?

1. Multi-dimensional concrete model.
nDmaterial PlaneStressUserMaterial $matTag 40 7 $fc $ft $fcu $epsc0 $epscu $epstu $stc $matTag
nDmaterial PlateFromPlaneStress $newmatTag $matTag $OutofPlaneModulus $newmatTag

2. Multi-dimensional Reinforcement Material
nDmaterial PlateRebar $newmatTag $matTag $sita $newmatTag

3. Define the Section of the Multi-layer Shell element
section LayeredShell $sectionTag $nLayers $matTag1 $thickness1...$matTagn $thicknessn $sectionTag

saeedunknown · Post by **saeedunknown** » Fri Jan 01, 2016 1:17 am

saeedunknown · Post by **saeedunknown** » Wed Jan 06, 2016 7:03 am

Does not anyone?

The OpenSees Community

Define the Section of the Multi-layer Shell element

Define the Section of the Multi-layer Shell element

Re: Define the Section of the Multi-layer Shell element

Re: Define the Section of the Multi-layer Shell element