question about defining multilinear material

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
omidgahremani
Posts: 24
Joined: Thu Nov 13, 2014 1:32 pm
Location: Mohaghegh university of ardebil, iran
Contact:
Contact omidgahremani

question about defining multilinear material

Post by omidgahremani »

in this command is the number of points arbitary or we need to define a specific number of points to form the envelop?
and if we need to define the negative part of the envelop we must enter that points ditinctly or defining the positive part of the envelop is enough ?
I am very grateful for your attention and kind help.
Top
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:
Contact fmk

Re: question about defining multilinear material

Post by fmk »

it is arbitray .. for negative you et the same as positive (but of course flipped) for the negative.
Top
Post Reply

Return to “OpenSees.exe Users”